Filter
Top Products
76 | Removing the System Board
Procedure
NOTE: Your computer’s Service Tag is stored in the system board. You must enter
the Service Tag in the BIOS after you replace the system-board assembly.
NOTE: Before disconnecting the cables from the system-board assembly, note the
location of the connectors so that you can reconnect them correctly after you
replace the system-board assembly.
1 Pull the pull-tab to disconnect the display cable from the system-board connector.
2 Remove the screws that secure the system-board assembly to the computer base.
3 Turn the system-board assembly over along with the hard-drive cable.
1 system-board assembly 2 display cable
3 pull-tab 4 screws (4)
1
2
3
4
book.book Page 76 Tuesday, April 17, 2012 11:08 AM