Filter
Top Products
ISA Configuration Utility Messages C-1
$33(1',;&
,6$&RQILJXUDWLRQ8WLOLW\
0HVVDJH V
The ISA Configuration Utility (ICU) and its Configuration Manager are capable of iden-
tifying problems and alerting you to them. Both utilities can alert you to problems with
card configuration as well as problems that prevent proper operation of the utility. This
appendix describes each type of message and lists the possible causes and actions
you can take to resolve any problems indicated by a message. See the following
tables to locate your message and identify any possible corrective actions.
,&8(UURU0HVVDJHV
The ICU can display a variety of error messages while in operation. These messages
alert you to problems that prevent the ICU from running correctly, as well as informing
you of resource conflicts that prevent the configuration of various cards in your com-
puter. If you receive a message from the ICU, see Table C-1 for suggestions on
resolving any problems indicated by the message.
Out of memory
Memory allocation failed
Either of these messages
can appear if the system
runs out of memory during
your operation.
Disable any terminate-and-stay-resident
(TSR) programs or any unneeded
device drivers.
Not enough memory to run
the ICU
This message appears
when you start the ICU if
the system does not have
enough memory to run the
utility.
Can’t open index file.
This file is required for
ICU to run.
The ICU cannot find the
index file for its database.
Make sure to switch to drive A before
attempting to start the utility.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.