Filter
Top Products
Using the System Setup Program 3-13
password. See “Disabling a Forgotten Password” found later in this chapter for
instructions on disabling a forgotten setup password.
Chassis Intrusion displays the status of the system chassis intrusion monitor.
If the computer cover is removed, the setting changes from Not Detected to
Detected and the following message is displayed during the boot sequence at system
start-up:
Alert! Cover was previously removed.
To clear this field and allow future intrusions to be detected, enter the System Setup
program, as described in “Entering the System Setup Program” found earlier this
chapter. At the Chassis Intrusion option, use the left- or right-arrow key to choose
Reset. Then press <Esc> to save the changes and reboot the system.
NOTE: When enabled, the setup password is required in order to reset the Chassis
Intrusion option from Detected to Not Detected. You cannot reset the Chassis Intru-
sion option without a password.
.H\ERDUG1XP/RFN
Keyboard NumLock determines whether your system boots with the Num Lock mode
activated on 101- or 102-key keyboards (it does not apply to 84-key keyboards).
When Num Lock mode is activated, the rightmost bank of keys on your keyboard pro-
vides the mathematical and numeric functions shown at the tops of the keys. When
Num Lock mode is turned off, these keys provide cursor-control functions according to
the label on the bottom of each key.
5HSRUW.H\ERDUG(UURUV
Report Keyboard Errors
enables or disables reporting of keyboard errors during power-
on self-test (POST), which is a series of tests that the system performs on the hard-
ware each time you turn on the system or press the reset button.
This option is useful when applied to self-starting servers or host systems that have
no permanently attached keyboard. In these situations, selecting
Do Not Report sup-
presses all error messages relating to the keyboard or to the keyboard controller
during POST. This option does not affect the operation of the keyboard itself if a
keyboard is attached to the computer.
$XWR3RZHU2Q
Auto Power On allows you to set the time and days of the week to turn on the com-
puter system automatically. You can set Auto Power On to turn on the system either
every day or every Monday through Friday.
NOTE: This feature does not work if you turn off your system using a power strip or
surge protector.