Filter
Top Products
Using the ISA Configuration Utility 4-13
A message box appears, notifying you either that the card is using its default set-
tings or that it cannot use its default settings and must be reconfigured.
NOTE: After modifying the system configuration, you must turn off the system to
install, remove, or change jumper settings on the non-Plug and Play ISA expansion
cards to match the settings you selected in the ICU.
5HPRYLQJD&DUG
Before you remove a non-Plug and Play ISA expansion card from your computer, you
must use the ICU to remove the card from the system configuration.
NOTE: When you remove a Plug and Play or PCI expansion card from your computer,
you do not need to run the ICU. To remove a Plug and Play or PCI expansion card,
complete steps 2 through 8 in “Removing an Expansion Card” in Chapter 9.
Use the following procedure to remove a non-Plug and Play ISA expansion card from
your computer:
The ICU requests verification that you want to remove the card.
The ICU returns to the ICU window.