Filter
Top Products
Using the System Setup Program 3-23
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
See “Chassis Intrusion” earlier in the chapter for instructions.
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
NOTE: Before you assign a new system and/or setup password, you must
replace the PSWD jumper plug.
Booting with the PSWD jumper installed reenables the password feature. When
you enter the System Setup program, both password options appear as Not
Enabled, meaning that the password feature is enabled but that no password has
been assigned.
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
See “Chassis Intrusion” earlier in the chapter for instructions.
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
To assign a new system password, see “Assigning a System Password” found
earlier in this chapter. To assign a new setup password, see “Assigning a Setup
Password” found earlier in this chapter.