Filter
Top Products
ISA Configuration Utility Messages C-3
This device is unconfig-
urable because of a
resource conflict with
card
card_name
. The con-
flicting resource is
resource_name
. To fix,
reconfigure the
conflicting card.
The selected card is
unconfigurable because
one of its resources is
already being used by
another device.
Perform the following procedure:
resource_name
card_name
The ICU has successfully
configured all Plug and
Play cards in your sys-
tem. For the new configu-
ration to take effect,
save the configuration,
then reboot your system.
The ICU has successfully
configured all of the Plug
and Play expansion cards
that were not configured by
the Configuration Manager.
To accept these settings, save the con-
figuration information into NVRAM by
selecting Exit from the File menu and
then selecting Yes to save. You must
reboot your system for these settings
to take effect.
The loaded card is not a
category card. Press OK
to proceed.
The category you have
chosen is not the correct
category under which to
add this card.
Select OK. The ICU automatically opens
the correct category’s dialog box.
Continue the procedure for adding the
card as described in “Adding a Listed
Card” or “Adding an Unlisted Card” in
Chapter 4.
No more DMA values can be
added.
No more interrupt values
can be added.
No more memory values can
be added.
No more I/O port values
can be added.
No more values are avail-
able for the resource you
are trying to add or modify.
The maximum number of values for
each resource is as follows:
4 DMA channels
7 IRQ lines
9 memory address blocks
20 I/O ports
To free values for the resource you are
trying to add or modify, delete some of
the values listed in the resource box for
the card. If your card requires all of the
values listed, contact your card manu-
facturer to resolve the issue.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.