Filter
Top Products
Removing and Installing Parts 129
10
Replace the support bracket (see "Replacing the Support Bracket" on
page 161).
11
Replace the computer cover (see "Replacing the Computer Cover" on
page 162).
NOTICE: To connect a network cable, first plug the cable into the network port or
device and then plug it into the computer.
12
Connect your computer and devices to electrical outlets, and then turn
them on.
13
See the documentation that came with the drive for instructions on
installing any software required for drive operation.
14
Check the system setup for drive configuration changes (see "Entering
System Setup" on page 170).
Installing a Second Hard Drive
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from
the electrical outlet before removing the cover.
NOTICE: To avoid damage to the drive, do not set it on a hard surface. Instead, set
the drive on a surface, such as a foam pad, that will sufficiently cushion it.
1
Follow the procedures in "Before You Begin" on page 99.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 101).
3
Remove the support bracket (see "Removing the Support Bracket" on
page 102).
4
Check the documentation for the drive to verify that it is configured for
your computer.
5
Attach the shoulder screws to the hard drive.