Filter
Top Products
About Your System 57
Unable to launch
System Services
image. System
halted!
System halted after F10
keystroke because System
Services image is either
corrupted in the system
firmware or has been lost due
to system board replacement.
Restart the system and
update the Lifecycle
Controller repository to the
latest software to restore full
functionality. See the
Lifecycle Controller user
documentation for more
information.
The iDRAC6 Enterprise card
flash memory may be
corrupted.
Restore the flash memory
using the latest version on
support.dell.com. See the
iDRAC6 user's guide for
instructions on performing a
field replacement of the flash
memory.
Unexpected
interrupt in
protected mode.
Improperly seated memory
modules or faulty
keyboard/mouse controller
chip.
Reseat the memory modules.
See "Troubleshooting System
Memory" on page 181. If the
problem persists, see
"Getting Help" on page 203.
Unsupported CPU
combination.
Unsupported CPU
stepping
detected.
Processor(s) is not supported
by the system.
Install a supported processor
or processor combination.
See "Processors" on page 148.
Warning: A fatal
error has caused
system reset!
Please check the
system event log!
A fatal system error occurred
and caused the system to
reboot.
Check the SEL for
information that was logged
during the error. See the
applicable troubleshooting
section in "Troubleshooting
Your System" on page 173 for
any faulty components
specified in the SEL.
Message Causes Corrective Actions
book.book Page 57 Wednesday, January 20, 2010 10:20 AM