Filter
Top Products
Back to Contents Page
Display
Dell™Latitude™E6500ServiceManual
Removing the Display Assembly
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the
Regulatory Compliance Homepage at: www.dell.com/regulatory_compliance.
1. Follow the instructions in Before Working on Your Computer.
2. Close the display and turn the computer over.
3. Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly).
4. Remove the hinge covers (see Removing the Hinge Covers).
5. Disconnect the display cable, the WPAN cable, and the modem cable.
6. Unroute the display cable and the wireless cables (WLAN, WWAN, and WPAN).
7. Remove the M2.5 x 5-mm screws from each hinge.
Removing the Display Assembly
Replacing the Display Assembly
Removing the Display Bezel
Replacing the Display Bezel
Removing the Display Panel
Replacing the Display Panel
Removing the Display Panel Brackets
Replacing the Display Panel Brackets
Display Inverter
Removing the Camera and Microphone Assembly
Replacing the Camera and Microphone Assembly
Removing the Latch Hook Assembly
Replacing the Latch Hook Assembly
Removing the Display Cover
Replacing the Display Cover
NOTE: Some graphics may vary slightly, depending on whether you ordered a cold-cathode fluorescent lamp (CCFL) display or an LED display.
CAUTION: After unrouting the cables, place all cables to the rear and away from the computer.
1
display cable
2
WPAN cable
3
WLAN cable
4
WWAN cable
1
M2.5 x 5-mm screws (2)