Filter
Top Products
NOTE: It is recommended that you always use a antistatic mat and antistatic wrist strap while
working on components inside the system.
NOTE: To ensure proper operation and cooling, all bays in the system must be populated at all
times with either a system component or with a blank.
Recommended tools
You may need the following items to perform the procedures in this section:
• #1 and #2 Phillips screwdrivers
• #2 Phillips round screwdriver
• T8 and T10 Torx drivers
• Wrist grounding strap
• 5 mm and 6 mm Hex nut drivers
Before working inside your system
1. Turn off the server module using the CMC.
2. Remove the server module from the enclosure.
3. Install the I/O connector cover.
4. Remove the system cover. See Removing the system cover.
After working inside your system
1. Install the system cover. See Installing the system cover.
2. Install the server module in the enclosure.
3. Turn on the server module.
Removing and installing a server module
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: These procedures are applicable only for full-height and half-height server modules. For
information on removing and installing quarter-height server modules from a sleeve, see the server
module's Owner's Manual at dell.com/poweredgemanuals.
Removing a server module
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
37