Filter
Top Products
4. Remove the hard drive(s)/SSD(s).
Steps
1. Press the release latches, lift the backplane until the guide pins on the hard drive/SSD cage disengage
from the guides on the hard drive/SSD backplane.
2. Remove the hard drive/SSD cage. See Removing a hard drive/SSD cage.
3. Loosen the two retention screws securing the hard-drive/SSD backplane cable connector to the
system board connector.
4. Lift the backplane away from the system.
Figure 33. Removing a 2.5 inch (x4) SAS hard drive/SSD backplane
1. hard drive/SSD backplane 2. release latch (2)
3. guide pin (5) 4. retention screw on the hard-drive/SSD
backplane cable connector
5. connector 6. hard-drive/SSD backplane cable
Next steps
1. Install the hard drive/SSD backplane.
Related Links
Installing a 2.5 inch (x4) SAS hard drive/SSD backplane
Removing a server module
Removing the system cover
90