Filter
Top Products
Installing a server module
Prerequisites
Ensure that you read the Safety instructions.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: To prevent damage to the I/O connectors, do not touch connectors or the connector
pins.
NOTE: Before installing the server modules, place the chassis in the location that you want.
NOTE: Install the server module partitions to install half-height server module(s). For more
information, see the Dell PowerEdge VRTX Enclosure Owner’s Manual at dell.com/
poweredgemanuals
.
Steps
1. If you are installing a new server module, remove the plastic cover from the I/O connector(s) and
save for future use.
2. Orient the server module so that the module handle is on the left side of the server module.
CAUTION: While installing the server modules, ensure that they are properly aligned with the
slots, to prevent damage to the server module connectors.
3. Align the server module with the server module slot and guide rails on the enclosure.
4. Slide the server module into the enclosure until the module release handle engages and the server
module is locked in place.
Next steps
1. Turn on the server module.
2. If applicable, install the front bezel of the PowerEdge VRTX enclosure.
Removing and installing the system cover
Removing the system cover
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: You must remove the system cover to service other components inside the system.
1. Ensure that you read the Safety instructions.
2. Turn off the server module using CMC.
3. Remove the server module from the enclosure.
4. Install the I/O connector cover.
39