Filter
Top Products
72 Adding Parts
www.dell.com | support.dell.com
7
Pull the two front-panel tabs towards you, and then push out the front-panel insert.
8
Ensure that the jumper setting on the new drive is set for "cable select" (see the
documentation that came with the drive for information).
9
Remove two extra alignment screws, shown in the illustration on page 72, from the front of
the computer and insert them into the drive.
NOTE: Some computers come with only two extra alignment screws; others come with four. You only
need two alignment screws for this procedure.
10
Gently slide the drive into place.
tabs (2)
insert
drive
alignment screws (2)