Filter
Top Products
120 Installing System Components
Figure 3-26. Removing or Installing an Expansion Card
Removing Expansion-Card Riser 1
WARNING: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
NOTE: You must remove all expansion cards from the expansion-card riser before
removing the riser from the system.
NOTE: The system will not start with a riser board removed.
1
Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2
Open the system. See "Opening the System" on page 78.
3
Disconnect all cables connected to the expansion card.
1 front card guide 2 expansion-card riser 2
3 expansion-card connector 4 expansion-card guide latch
5 expansion card
1
5
3
4
2