Filter
Top Products
92 Installing System Components
5
Install the iDRAC6 Enterprise card:
a
Angle the card so that the RJ-45 connector fits through the back-panel
opening. See
Figure 3-10.
b
Align the front edge of the card with the two front plastic retention
standoffs next to the iDRAC6 connector on the system board. See
Figure 6-2 for the location of the connector.
c
Press the card down until it is fully seated. See Figure 3-10.
When the front of the card is fully seated, the plastic standoffs snap
over the edge of the card.
6
Reinstall all expansion cards in expansion-card riser 1. See "Installing an
Expansion Card."
7
Close the system. See "Closing the System."
8
Reconnect the system and peripherals to their power sources, and turn
them on.
Figure 3-10. Removing and Installing the iDRAC6 Enterprise Card
1 iDRAC6 Enterprise card 2 VFlash media slot
3 VFlash SD card 4 RJ-45 Ethernet port (underneath
card)
5 retention standoff posts (2) 6 iDRAC6 Enterprise card connector
2
6
1
5
4
3