Filter
Top Products
22 About Your System
Bad error-correction
code (ECC) on disk read
The diskette or hard-
drive controller
detected an
uncorrectable read
error.
See "Troubleshooting a
Diskette Drive" on
page 116 or
"Troubleshooting a Hard
Drive" on page 120.
CAUTION! NVRAM_CLR
jumper is installed on
system board. Please
run SETUP
NVRAM jumper is
installed.
After an NVRAM jumper
is installed, run the
System Setup program.
See "Using the System
Setup Program" on
page 31.
CD-ROM drive not found The operating system
cannot read from the
CD-ROM drive.
See "Troubleshooting an
Optical Drive" on
page 118.
Controller has failed The hard drive or the
associated controller is
defective.
See "Troubleshooting a
Hard Drive" on page 120.
Data error The diskette drive or
hard drive cannot read
the data.
For the operating
system, run the
appropriate utility to
check the file structure
of the diskette drive or
hard drive. See your
operating system
documentation for
information on running
these utilities.
Decreasing available
memory
One or more memory
modules might be
faulty or improperly
seated.
Reinstall the memory
modules and, if
necessary, replace them.
See "Troubleshooting
System Memory" on
page 114.
Table 1-6. System Messages (continued)
Message Causes Corrective Actions
book.book Page 22 Wednesday, April 15, 2009 8:47 PM