Filter
Top Products
52 Installing System Components
Figure 3-5. Removing and Replacing the Blank Drive Insert
Diskette Drive
The 3.5-inch drive bay supports an optional standard diskette drive.
Removing the Diskette Drive
CAUTION: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before performing any
procedure, see your Product Information Guide for complete information about
safety precautions, working inside the computer and protecting against
electrostatic discharge.
1
Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2
Open the system. See "Opening the System" on page 47.
3
Remove the front drive bezel. See "Removing the Front Drive Bezel" on
page 49.
1 tab 2 blank drive insert
3 drive blank alignment screw
2
3
1
book.book Page 52 Wednesday, April 15, 2009 8:47 PM