Filter
Top Products
186
D.2 Interface Cables
With the interface cables described in this section, DENSO WAVE has run the quality
assurance test conforming to the EMC Directive for the BHT-100Q/100B series and CU-
7001.
Any connectors other than those specified here are not acceptable. They may cause
the BHT or CU to fail to work according to the specifications.
For BHT
Cable 1
Wind the cable on a ferrite core twice and then secure the core with a heat-shrinkable
tube.
➀ Connector P161 Teisin Electric Co., Ltd.
➁ D-sub connector D -F-T-N series (EMI-durable) Japan Aviation
Electronics Industry Ltd.
➂ Connector cover 17JE series hood/cable clamp DDK Ltd.
(shielded)
➃ Cable Super flex VVC 7/0.18 mm x 3C Bando Densen Co., Ltd.
➄ Ferrite core ZCAT2035-0930A TDK Corporation
➅ Heat-shrinkable tube
Note: A square ( ) in the above specifications denotes a numeral that will vary
according to the number of connector pins.