Filter
Top Products
10/100 Fast Ethernet Switch User’s Guide
8
Unpacking and Setup
Figure 2-2B. Installing the 10/100 Fast Ethernet Switch in an
equipment rack
Power on
The DES-3208 Switch can be used with AC power sources 100 - 240 VAC,
50 - 60 Hz. The power switch is located at the rear of the unit adjacent to the
AC power connector and the system fan. The Switch’s power supply will
adjust to the local power source automatically and may be turned on without
having any or all LAN segment cables connected.
After the power switch is turned on, the LED indicators should respond as
follows:
♦
All LED indicators will momentarily blink. This blinking of the LED
indicators represents a reset of the system.