D-Link DWA-140 Network Router User Manual


 
DSL-G604T DSL Router Users Guide
iv
LAN Subnet Mask for the
DSL-G604T
This is the subnet mask used by the DSL-G604T, and will be
used throughout your LAN. The default subnet mask is
255.0.0.0. This can be changed later.
Information you will need about your LAN or computer:
Ethernet NIC
If your computer has an Ethernet NIC, you can connect the
DSL-G604T to this Ethernet port using an Ethernet cable.
You can also use the Ethernet port on the DSL-G604T to
connect to other Ethernet devices, such as a Wireless
Access Point.
Record info here
DHCP Client status
Your DSL-G604T ADSL Modem is configured, by default, to
be a DHCP server. This means that it can assign an IP
address, subnet mask, and a default gateway address to
computers on your LAN. The default range of IP addresses
the DSL-G604T will assign are from 192.168.1.2 to
192.168.1.254. Your computer (or computers) needs to be
configured to Obtain an IP address automatically (that is,
they need to be configured as DHCP clients.)
It is recommended that your collect and record this information here, or in some other secure place, in case you
have to re-configure your ADSL connection in the future.
Once you have the above information, you are ready to setup and configure your DSL-G604T ADSL Router.
Note
The Modem may be reset to its factory default settings by performing a Restore settings
operation within the management interface (see System Commands). If you cannot
gain access to the management interface, you may opt to use the Reset button on the
rear panel of the device (see
錯誤
!
不到源。
below).
Packing List
Open the shipping carton and carefully remove all items. Make sure that you have the items listed here.
1. One DSL-G604T 802.11g Wireless ADSL Ethernet Router
2. One CD-ROM containing the Users Guide
3. One twisted-pair telephone cable used for ADSL connection
4. One straight-through Ethernet cable
5. One AC power adapter suitable for your electric service
6. One Quick Installation Guide