Filter
Top Products
6.5:
Nexus
Information
Mode
Q
Use the MODE button to access the Nexus Information Mode from other Modes. Use the
UP/DOWN arrows to navigate from Group to Group within this Mode. See section 6.6 for a
navigational map of the Nexus Information Mode.
Q
Group 1: Device Time
• Meter Time
Q
Group 2: Communication Settings (Use the LEFT/RIGHT arrows to access the following readings,
in order.)
• Communication Settings Port 1: Baud/Addr/Protocol
• Communication Settings Port 2: Baud/Addr/Protocol
• Communication Settings Port 3: Baud/Addr/Protocol
• Communication Settings Port 4: Baud/Addr/Protocol
Q
Group 3: PT, CT Ratios (Use the LEFT/RIGHT arrows to access the following readings, in order.)
• PT Ratio
• CT Ratio
Q
Group 4: External Display Units
• Primary/Secondary
• Select either Primary or Secondary units for the External Display using the Communicator EXT
software (see the Energy Manager User Manual).When Primary is selected, the Display shows
all readings in Primary units based on the user programmed PT and CT Ratios. When Secondary
is selected, the Display shows all readings in Secondary units.
Q
Group 5: Firmware Versions and Serial Numbers (Use the LEFT/RIGHT arrows to access the
following readings, in order.)
• Run Time External Display/Run Time DSP/RunTime Comm
• Boot External Display/Boot DSP/Boot Comm
• Serial Number External Display; Serial Number Nexus Monitor
Electro Industries/GaugeTech
Doc # E107706 V1.25 6-6