Filter
Top Products
2-46 IntelliTouch/SecureTouch Guide
• Connect the 2x5 position header of cable 429761-000 to connector P4 of the
IntelliTouch USB controller, and secure with a small amount of glue.
• Take up the excess cable with zip ties and secure.
Modifying the Case for Serial Output
To modify the case to accommodate the RS-232 output cable:
1 Evaluate the rear of the case to determine the best position for the DB-9
connector. A hole for this connector may be furnished in a variety of ways:
• Mounting the connector to an internal chassis member with a hole cut in
the rear case to expose the connector.
• Punching a DB-9 style hole in the exterior of the case, and mounting the
connector directly to the case. (Such DB-9 punches can be obtained from
industrial supply vendors).
2 Mount the DB-9 header of the RS-232 output cable (part number: 942741-
000) using one of the above techniques.
Note:
If mounting to a non-grounded location, attach a grounding cable to one of the
jackscrews and terminate to ground.
3 Connect the 2x5 header of the RS-232 output cable (part number: 942741-
000) to connector P2 of the IntelliTouch serial controller, and secure with a
small amount of glue.
4 Take up the excess cable with zip ties and secure.
5 Adhere the metal plate labeled with the legend, “Touchscreen Interface” to
the case area surrounding the DB-9 connector.
6 Label the monitor to indicate that an IntelliTouch 2500S controller has been
installed inside the display.
Modifying the Case for USB Output
To modify the case to accommodate the USB output cable (included with the
USB cable pack):
1 Evaluate the rear of the case to determine the best position to punch for the
bulkhead’s hole. This hole may be furnished in a variety of ways:
• Mounting the bulkhead to an internal chassis member with a hole cut in
the rear case to expose the connector.
• Punching a rectangular style hole in the exterior of the case, and mounting
the bulkhead directly to the case. (Such punches can be obtained from
industrial supply vendors).