Filter
Top Products
2--9 Settings
General Settings
Th e con tro ller (CP) general setting can be displayed and changed from the keypad.
Some settings may require a password (if the controller is set up for one).
¡ From any of the Status displays, press Enter/Save Settings ¿ key to move to
the Settings level of menus.
© Press the right arrow " key to m ove to Setting Time Delays menu.
¢ Press the right arrow " key again to move to Settings Features menu.
£ Press the right arrow " key again to move to Settings General menu.
¤ Now p ress Enter/Save Settings ¿ keytomovetothefirstGeneral display
¥ You can press the right arrow " key to see the other General menus (as shown
below). An overview explanation of each setting is listed below.
6 General Settings Menus (last menu loops back to first)
Default to Factory Settings seepage2–1
This display (upper half) allows the user to reset the majority of controller
settings to their factory default values.
Reset Engine Exerc Programs seepage2–1
This display (lower half) also allows the user to reset the engine exerciser
routines. YES means reset. NO means do not reset.
Menu Language (not shown) see page 2–1
Thisdisplayshowsthelanguageinwhichthemessageswillbeshown.
English is the default language.
Serial Communication seepage2–1
This display allows the user to configure the serial communications port of the
controller.
Baud Rate — off, 9600, x9600. 19.2 k, Mbus9600, Mbus19.2k
x9600 selects 9600 and the Group 1/7 CP protocol
Address — can be set from 0 to 63
Event Logging seepage2–1
This display allows the user to enable the event logging feature of the
controller and to clear the event log.
Enable — YES means to start event logging; NO means turn it off.
Print Enable — YES means enables printer option; NO turns it off.
Clear Log — YES means erase the event log; NO means keep it.
PrintEventLog(not shown) see page 2–1
This display shows the status of the optional printer.
Also see Printer Interface Module instructions 381339---218.
User Controls Locked (on 4000 Series only)
seepage2–1
This display allows the user to lock or unlock the door–mounted user controls.
(not the Power Control Center). YES means locked. NO means unlocked.
Change Password seepage2–1
This display allows the user to change t he controller password.
SETTINGS
Voltage DO PU
Frequency DO PU
¡
©
Default to Factory
Settings:
Reset Engine Exerc
Programs:
SERIAL
COMMUNICATION
Baud Rate:
Address:
EVENT LOGGING
Enable:
Print Enable:
Clear Log:
Change
Password:
0001
SETTINGS
General
£
¤
¥
¢
User Ctrls Lckd: