Filter
Top Products
2--14Settings
Service — Factory Selectable Features
The controller service factory selectable features can be displayed from the
membrane controls. These factory settings should not be changed by the customer
(they cannot be changed without entering t he factory p assword).
¡ From the ATS Status display (NORMAL OK), press Enter/Save Settings
button to move down to the Settings level of menus.
©¢£¤¥¦§ Press right arrow " button 7 times
to move to Service menu.
¨ Now press Enter/Save Settings button to move down to the first Service
factory selectable feature.
You can press the right arrow " button to see the other Service menus (as shown
below). An overview explanation of each setting is listed below.
8 Service Menus (last menu loops back to first)
ATS Information
This display shows the transfer switch ampere size, whether the switch is a
bypass switch or a non–bypass switch, and any name or description inform–
ation that has been assigned to it through the serial communications port.
Test or Manual Mode Input
This display shows the setting of the Feature 5/6Z input. This input can be
used for either Feature 5 or 6Z. Yes means active; no means not used.
Test Operation — Feature 5
Manual Operation — Feature 6Z
This Feature is not available for automatic operation.
Retransfer Mode Input
Th is disp lay sho ws t he set ting s for Features 6B /6C in put s. This inp ut can be used
for eith er Feat ure 6B or 6C. Yes means act ive; no means not used .
TD Bypass — Feature 6B
Manu al R e Xfer — F eat ure 6C
Th ese F eatures are typically set to Ye s with the inhibit Feature ove rridden with
exte rnal facto ry wiring . These F eatu res are not available fo r custo mer use.
Xfer to Normal Inhibit and Emergency (not shown)
This display shows whether the Feature 34A input is enabled (yes) or disabled
(no).
Likewise, the next display Xfer to Emerg shows whether the Feature 34B input
is enabled (yes) or disabled (no).
Factory Calibration (not shown)
This display is for factory calibration only and should be used by factory
personnel only.
Other
These displays show various parameters that should be accessed by factory
personnel only.
NORMAL OK
SETTINGS
Voltage DO PU
Frequency DO PU
¡
©¢£
¤¥¦§
ATS INFORMATION
ATS:
TEST OR MANUAL MODE
INPUT
Test Operation:
Manual Operation:
RETRANSFER MODE
INPUT
TD Bypass:
Manual Re Xfer:
XFER TO NORMAL
INHIBIT
Enable:
Temp Calibr:
ATS Idle Time: ms
CT Parallel TD: ms
SERVICE
Factory
Selectable Features
¨
press
7times