2 --- 1 1 Settings
Engine Exerciser S ettings
The controller (CP) engine exerciser setting can be displayed and changed from
the keypad. Some settings may require a password (if the controller is set up for
one).
① From any of the Status displays, press Enter/Save Settings keytomovetothe
Settings level of menus.
② Press the right arrow key to move to Setting Time Delays menu.
③ Press the right arrow key again to move to Settings Features menu.
④ Press the right arrow key again to move to Settings General menu.
⑤ Press the right arrow key again to move to Settings Engine Exerciser.
➅ Now press Enter/Save Settings keytomovetothefirstEngine Exerciser menu.
➆ You can press the right arrow key to see the other Engine Exerciser menus
(as shown below). An overview explanation of each setting is listed below.
8 Engine Exerciser Settings M enus
(last menu loops back to first)
Present Date/Time seepage2–1
This display allows the user t o change t he controller date and time.
US DST — US Daylight Saving Time. APR – OCT, MAR – NOV, or OFF.
MAR – NOV begins in 2007.
P(1—7) Engine Exerciser(s) seepage2–1
These displays (P1 through P7) allow the user to set the controller’s seven
independent engine exerciser routines. Each routine functions in the same
manner. Six parameters need to be configured for each routine (P1, P2, P3,
P4, P5, P6, P7 — not al l have to be used).
Enable — YES e n ables the routine; NO turns it off.
wLoad — YES transfers load to Emergency; NO = no transfer.
Start — when the routine will start the generator
– time (hour, minute)
– week (all, alternate, 1st, 2nd, 3rd, 4th, or 5th week)
–dayoftheweek(mon,tue,wed,thu,fri,sat,sun)
Run Time — duration (length of time) that the generator will run.
SETTINGS
Voltage DO P U
Frequency DO PU
①
PR ESENT DAT E/T IME
US DST:
Date:
Time:
P1 ENGINE EX ERCISER
Enable: wLoad:
Start: h
Run Time: h min
SETTINGS
Engine Exerciser
➅
②③
④⑤
➆
P7 ENGINE EX ERCISER
Enable: wLoad:
Start: h
Run Time: h min
Set the se ven
independe nt
engine exercise
routines,
if desired.