Filter
Top Products
Safety Information iii
Safety Information Product Overview Installation Diagnostics
Options and
Accessories
Specification
Safety Information
Safety Precautions
This product is intended for professional incorporation into a complete system by qualified persons. If you install the
product incorrectly, it may present a safety hazard. The product and system may use high voltages and currents,
carry a high level of stored electrical energy, or are used to control mechanical equipment that can cause injury.
You must give close attention to the electrical installation and system design to avoid hazards either in normal
operation or in the event of equipment malfunction. System design, installation, commissioning and maintenance
must be carried out by personnel who have the necessary training and experience. Read and follow this safety
information and this instruction manual carefully.
Qualified Person
For the purpose of this manual and product, a “qualified person” is one who is familiar with the installation,
construction and operation of the equipment and the hazards involved. In addition, this individual has the following
qualifications:
Is trained and authorized to energize, de-energize, clear and ground and tag circuits and equipment in accordance
with established safety practices.
Is trained in the proper care and use of protective equipment in accordance with established safety practices.
Is trained in rendering first aid.
Enclosure
This product is intended to be mounted in an enclosure that prevents access except by qualified persons and that
prevents the ingress of contamination. This product is designed for use in an environment classified as pollution
degree 2 in accordance with IEC664-1. This means that only dry, non-conducting contamination is acceptable.
Setup, Commissioning and Maintenance
It is essential that you give careful consideration to changes to drive settings. Depending on the application, a change
could have an impact on safety. You must take appropriate precautions against inadvertent changes or tampering.
Restoring default parameters in certain applications may cause unpredictable or hazardous operation.
Safety of Machinery
Within the European Union all machinery in which this product is used must comply with Directive 89/392/EEC,
Safety of Machinery.
The product has been designed and tested to a high standard, and failures are very unlikely. However the level of
integrity offered by the product’s control function – for example stop/start, forward/reverse and maximum speed – is
not sufficient for use in safety-critical applications without additional independent channels of protection. All
applications where malfunction could cause injury or loss of life must be subject to a risk assessment, and further
protection provided where needed.
Identification of Safety Information
Safety related information through out this manual is identified with the following markings.
“Warning” indicates a potentially hazardous situation that, if not avoided, could result in death or serious injury.
“Caution” indicates a potentially hazardous situation that, if not avoided, may result in minor or moderate
injury.