Filter
Top Products
Installation of the RTM-ATCA-7150
ATCA-7150 and RTM-ATCA-7150 Getting Started (6806800G42B)
60
Installation Procedure with Installed Front Blade
The following procedure describes the installation of RTM-ATCA-7150. It assumes that your
system is powered on. If your system is powered off, you can disregard the blue LED and thus
skip the respective step. In this case it is a purely mechanical installation. The same applies to
an installation without an installed front blade. In this case disregard the LEDs and skip the
respective step.
1. Wear the ESD-preventive wrist strap. For more information refer, Wearing the ESD-
Preventive Wrist Strap.
2. Fully open the ejector handles of the front blade.
3. Take RTM-ATCA-7150 out of the antistatic package.
4. Fully open the upper and lower ejector handles of the RTM.