Filter
Top Products
Hardware Installation of ATCA-7150
ATCA-7150 and RTM-ATCA-7150 Getting Started (6806800G42B)
91
3.7 Installing and Removing the Blade
3.7.1 Installation
RTM-ATCA-7150 must be installed before the ATCA-7150 to avoid product damage. For
information on how to install the RTM-ATCA-7150, refer to Chapter 2, Installation of the RTM-
ATCA-7150, on page 35
3.7.1.1 Installing the ATCA-7150 in a Powered Shelf
The following procedure describes the installation of the blade. It assumes that your system is
powered and if applicable the RTM is installed. If your system is unpowered, you can disregard
the blue LED and thus skip the respective step. In this case it is a purely mechanical installation.
1. Wear the ESD-preventive wrist strap.
For details, see Wearing the ESD-Preventive Wrist Strap on page 75
2. Take the ATCA-7150 out of the antistatic package.
3. Fully open the upper and lower ejector handles.
4. Slide the ATCA-7150 along the guide rails until the positioning pins of the ATCA-7150 are
inserted in the positioning holes in the shelf, as shown in Figure 3-8.
5. Make sure that the upper and lower ejector handles are attached to the beam properly.
Close the upper and lower ejector handles until the inner sides of the ejector handles are
attached to the face plate, as shown in Figure 3-8. After closing the handles, the blue LED,
OOS and HEALTHY LEDs blink. When payload is powered on, the blue LED is continously
illuminated, and the OOS and HEALTHY LEDs are out.