Filter
Top Products
RTM‐ATCA‐SXXXMechanicalandConnectorInformation
6806800H62B ATCA‐S201InstallationandUseGuide134
13.2.3 Serial Console Management Port
Port 4 is a low-profile RJ-45 connector jack that provides RS232 signaling. The port is
wired as pass-through to the front ATCA carrier via the J32/P32 Zone-3 connector
Table 65 Serial Console Management Port Connector Pin Assignments
Pin Signal Name Pin Signal Name
1 RTS 5 GND
2 DTR 6 RXD
3 TXD 7 DSR
4 GND 8 CTS
Figure 45 Serial Console Management Port Pin Location Diagram
13.2.4 Zone 3 Connectors
The RTM-ATCA-SXXX routes several I/O signals to the Zone-3 connector complex
consisting of connectors J30, J32 and J3. These connectors enable expansion using
rear transition modules (RTM) whose ‘J’ connectors mirror the ‘P’ connectors
located on the carrier module. All of these connectors utilize a 3-pin per column
type available from Tyco electronics (http://www.tycoelectronics.com), part
number 6469081-1
.
Note: The connector pin-outs are presented from the point of view of ATCA blade,
such that:
‘TX’ refers to ATCA blade as the signal source, and RTM as the signal receiver.
‘RX’ refers to ATCA blade as signal receiver, and RTM as the signal source.