Filter
Top Products
RTM-ATCA-SXXX Overview
6806800H62B ATCA‐S201InstallationandUseGuide43
CLI command syntax
Table 21 CLI command syntax, set network property: Ethernet port configuration
Convention: atca_blade set_network Y <portcode+> <enable> <dhcp> <ipaddr> <netmask>
<broadcast> <gateway> <MAC> <MTU> +
<portcode> Use portcode 16+ to modify eth0
Use portcode 24+ to modify eth1
Use portcode 32+ to modify eth2
Use portcode 40+ to modify eth3
Use portcode 48+ to modify eth4
Use portcode 52+ to modify VLAN
<enable> 0|1
Value 0 disables the port, value 1 enables the port.
<dhcp> 0|1
Value 0 disables dhcp, value 1 enables the dhcp. When enabled, other network
input fields are ignored. (ipaddr, netmask etc.)
Remaining
inputs
ipaddr, netmask input formats etc. are defined in the sections below
4.6.10 Enable (online/offline)
<Read/Write> The user may set a port online or offline with this menu box. When
enabled the port in online, and will terminate IP traffic. When the port is disabled, IP
packets are not processed.
4.6.11 DHCP
<Read/Write> The user may configure any port for Dynamic Host Configuration
Protocol (DHCP). If DHCP is enabled, the port will search for a DHCP server to
automatically set the IP address, subnet mask, default gateway address.
4.6.12 IP address
<Read/Write> The user may manually assign the IP address of a port, if DHCP is NOT
enabled. The address must be entered using dotted decimal notation. (e.g.
192.168.1.211)
4.6.13 Network (Subnet) mask
<Read/Write> The user may manually assign the subnet mask of a port, if DHCP is
NOT enabled. The subnet mask must be entered using dotted decimal notation.
(e.g. 255.255.255.0)