Filter
Top Products
RTM-ATCA-SXXX Overview
6806800H62B ATCA‐S201InstallationandUseGuide26
3.5 Command line configuration tool
This tool is available from either the RS232 console or a linux secure shell
connection. After successful login, the user may run an executable file “atca_blade”
located in the /web/cgi-bin directory. The tool provides the user with a simple menu
interface, to perform interactive parameter modifications. A sample session is
shown below.
#ssh 192.168.1.xxx -l root
root@192.168.1.xxx's password: root
Last login: Tue Nov 20 17:34:30 2007 from 192.168.1.xxx
# cd /web/cgi-bin
/web/cgi-bin # atca_blade
3.5.1 Change IP address of any Ethernet resource
The ATCA-S201 provides multiple Ethernet interfaces that host blades may use for
initial setup and configuration. These ports are identified with the Linux resource
labels shown in the table below
Table 7 Ethernet ports for chassis communications (base/fabric)
Linux interface identifier description
/dev/eth0 Chassis Base port 0, 1Gb link
/dev/eth1 Chassis Base port 1, 1Gb link
/dev/eth2 RTM, Rear I/O management port.
/dev/eth3 Chassis fabric port 0, 10Gb XAUI link
/dev/eth4 Chassis fabric port 1, 10Gb XAUI link
Perform manual Interactive changes
After invoking the command line tool (atca_blade), the user can modify any of the
parameters within the functional groupings listed above. For example, select the “2.
Network Settings” group. The configuration tool will display the entire list
parameters in the group, along with their present values.
Main Page for CLI Interface
1. IPMI Settings (get_status)
2. Network Settings (set_network)
3. Hardware Raid Configuration (set_raid)
4. Logical Volume Mangager LVM2 Configuration (set_lvm2)
5. Manage Shares (set_shares)
6. smb Configuration (set_smb)
7. nfs Configuration (set_nfs)
8. iSCSI Configuration (set_iscsi)
9. Web gui enable (set_gui)
10. Allow Web and CLI at the same time (set_useroverride)
0. Exit
Enter choice [1-10], 0 to exit: [0]: 2
-------------- System Identification and TimeZone Active Settings -----
Hostname=[BladeHost]:
DomainName=[Emerson.com]