Filter
Top Products
RTM-ATCA-SXXX Overview
6806800H62B ATCA‐S201InstallationandUseGuide24
the clear password procedure is explained in section 9.4.3 of this manual. When
invoked, the user is prompted to set a new one at first login.
Note: The recovery procedure affects the “root” user only; No other user account
passwords are cleared.
3.3 Factory reset
Users can reset the blade to restore factory default settings. This procedure will
erase all existing blade configurations (network settings, volumes, shares etc). The
procedure is sometimes recommended following a major firmware upgrade.
i. Login into shell window as root
ii. At console prompt, type: fw_setenv setfactorydefaults 1
3.4 Configuring a new ATCA-S201 blade
Initial configuration and setup of your blade may be conducted over Ethernet or
serial (RS232) connections. Select the connection type that supports your preferred
management style, either CLI (command line tool) or HTML as outlined below:
Connection type Command line tool Secure html tool
Serial/RS232 port on RTM
Yes
Ethernet port on RTM
Yes Yes
Base or fabric ports on ATCA
Zone-2 connector
Yes Yes
3.4.1 Serial ports
An RJ45 serial port can be found on RTM panel. The default baud rate and
communication settings are listed in Table 5 Console port, default terminal
settings
in section 3.1.2. The serial port attributes such as baud rate may be changed in the
U-boot environment using the bootargs variable (see section 3.6.3 titled U-bo
ot
environm
ent variables).
3.4.2 Ethernet ports
An RJ45 Ethernet port can be found on RTM panel. It auto negotiates Ethernet link
speed s up to 1Gbps. Additional Ethernet ports (base and fabric) are provided on the
ATCA zone-2 connector. By default, all Ethernet ports will attempt to obtain an IP
address assignment form the DHCP (Dynamic Host Configuration Protocol) server
on the network. Administrators must log into your DHCP server to determine the IP
assignment. With the IP address, an administrator may connect to the ATCA-S201
using a secure shell (SSH) or an HTML browser which supports secure http
connections. The Ethernet equipment can be identified by finding the IP address(es)
corresponding to the following MAC address assignments:
MAC address OUI
00-11-0D-xx-xx-xx (hex)