Filter
Top Products
MITX-430/MITX-440-DVI-2E Installation and Use Guide (6806800K37B)
Safety Notes
118
Product Damage
Too much force may damage the reset switch.
Use minimal force when pressing the reset switch.
Grounding
Product Damage
If the product is not properly grounded, it may be damaged by electrostatic discharge.
Make sure that each of the system's parts contact the EMI gasket. The system contains gaskets
at the shelf and module level.
The shelf is also fitted with ESD contacts. Provide proper ESD protection for the operator.
Personal Injury
Touching the PEM power input terminals with metallic objects on your hands, wrists, or
hanging from your neck may lead to severe injuries through electric shock and burning.
Do not wear any metallic attire or commodity on your hands, wrists, or hanging from your
neck when working at the power input terminals or power input cables. Be extremely careful
when you use electrically conductive tools near the PEMs.
Electric Shock
Power Cable
If the power cable is not connected properly, you may get an electric shock.
To minimize shock hazard, the system chassis and enclosure must be connected to an
electrical ground. Failure to observe proper grounding practices may cause a variety of noise,
electrostatic discharge, and radio frequency interference (RFI) problems.
Electric Shock (AC Systems)
If the three-conductor AC power cable is not connected properly, you may get an electric
shock.
The power cable must be plugged into an approved three-contact electrical outlet with the
grounding wire reliably connected to an electrical ground (safety ground) at the power outlet.