Filter
Top Products
Hardware Preparation and Installation
MITX-430/MITX-440-DVI-2E Installation and Use Guide (6806800K37B)
40
2. Check for damage and report any damage or differences to the customer service.
3. Remove the desiccant bag shipped together with the product.
2.4 Preparing the Installation Environment
Before you install or replace components, pay attention to the following:
z Wear an ESD-preventive wrist strap to prevent the static electricity from damaging the
device.
z Keep the area where the components reside clean and keep the components away from
heat-generating devices, such as radiator.
z Ensure that your sleeves are tightened or rolled up above the elbow. For safety purposes,
it is not recommended to wear jewelry, watch, glasses with metal frame, or clothes with
metal buttons.
z Do not exert too much force, or insert or remove the components forcibly. Avoid damage
to the components or plug-ins.
z Confirm the feasibility of the operation
The spare parts of the components to be installed or replaced are available in the
equipment warehouse. When the available spare parts are lacking, contact Emerson
Network Power. For details on how to get help from Emerson Network
Power, visit http://www.emersonnetworkpower.com/embeddedcomputing.
Make sure that the new components are in good condition, without defects such as
oxidation, chemical corrosion, missing components, or transportation damage.
z Check the environment
Make sure that the power supply, temperature, and humidity meets the operating
requirements for the motherboard and its components. For details, refer to the respective
system documentation.
z Prepare the parts and the tools
Environmental Damage
Improper disposing of used products may harm the environment. Always dispose of used
products according to your country’s legislation and manufacturer’s instructions.