Filter
Top Products
Built-in Commands
11-16 Network Tools Screens
Syntax:
(Continued)
maclock set enable [ port# | all | global ]
Enables MAC locking globally or on one or more ports. When enabled and
configured for a specific MAC address and port string, this locks a port so
that only one end station address is allowed to participate in frame relay.
maclock set disable [ port# | all | global]
Disables MAC locking globally or on one or more ports.
maclock set <macaddress> < port# | all > < create | enable | disable>
Creates a static MAC address and enables or disables MAC locking for the
specified MAC address and port. When created and enabled, this allows
only the end station designated by the MAC address to participate in frame
relay.
maclock set firstarrival < port# | all > < value >
Restricts MAC locking on a port to a maximum number of end station
addresses first connected to that port.
maclock set static < port# | all > < value >
Restricts MAC locking on a port to a maximum number of static
(management defined) MAC addresses for end stations connected to that
port. Valid values are 0 to 20.
maclock set trap < port# | all > < enable | disable >
Enables or disables MAC lock trap messaging globally or one one or more
ports. When enabled, this authorizes the device to send an SNMP trap
message if an end station is connected that exceeds the maximum values
configured using the maclock set firstarrival and maclock set static
commands. Violating MAC addresses are dropped from the device’s
routing table.
maclock clear static < port# | all >
Clears statically configured MAC locking entries from one or more ports.
maclock clear <macaddress> < port# | all >
Clears a MAC locking entry from one or more ports.
maclock (Continued)