Filter
Top Products
Section 3: Installing and Configuring the Print Server
20 AXIS 1440 User’s Manual
Configuring the Print Server Using AXIS NetPilot
The AXIS NetPilot Installation Wizard enables you to install and
configure the AXIS 1440 for your network quickly and easily. You can
use it to configure the print server for multiple network protocols:
NetWare, NetBIOS/NetBEUI, TCP/IP, SNMP, and Apple
EtherTalk. However, you must run it on a Windows workstation (or
on an OS/2 workstation in a Win OS/2 window) connected to a
NetWare or NetBIOS/NetBEUI network.
Notes: ❏ If you’re installing and configuring the AXIS 1440 from a
Windows NT workstation, your display should not be set to a
generic video driver, such as VGA compatible. Before you start
AXIS NetPilot, make sure your display is set to the exact video
driver for your hardware. (Check your computer documentation
if you’re unsure of the correct video driver.) If you need to reset
your display setting, restart your computer before beginning this
procedure.
❏ If you have a network that supports NetBIOS/NetBEUI, you
don’t need to use the AXIS NetPilot Installation Wizard to
perform initial setup unless you want to change the default print
server name. Skip this procedure and go to Section 5 Setting Up
Windows Workstations.
1. Follow the instructions in Software Installation on page 18 to
install the AXIS software on your computer.
2. Double-click the NetPilot icon, which is located in the folder
where you installed AXIS NetPilot.