Filter
Top Products
Section 4: Performing Additional NetWare Setup
AXIS 1440 User’s Manual 31
Section 4 Performing Additional
NetWare Setup
This chapter describes how to use AXIS NetPilot to add print queues
to the AXIS 1440.
For information on how to use AXIS NetPilot to perform other
configuration tasks, see Using AXIS NetPilot on page 63.
If you plan to use the AXIS 1440 in a multiprotocol environment, you
need to set it up in each environment in your network. See the
relevant sections in this manual:
Section 5 Setting Up Windows Workstations on page 35
Section 6 Setting Up Macintosh Computers on page 47
Section 7 Setting Up OS/2 Workstations on page 49
Section 8 Setting Up - UNIX on page 53
Adding Print Queues to the AXIS 1440 Print Server
You can use AXIS NetPilot to add print queues to your AXIS 1440 in
both Print Server Mode and Remote Printer Mode. In Print Server
Mode, which is recommended for medium to large networks, the
AXIS 1440 emulates a workstation running PSERVER. In Remote
Printer Mode, recommended for small networks where the number of
NetWare user licenses may be limited, the AXIS 1440 emulates a
workstation running RPRINTER or NPRINTER. See your NetWare
documentation for more information about Printer Server Mode and
Remote Printer Mode.
Note: ❏ You must have performed basic installation and configuration of
the AXIS 1440 Print Server before you begin this procedure. See
Configuring the Print Server Using AXIS NetPilot on page 20.