Filter
Top Products
7.
If your computer still does not respond, you can reset it
using the Ctrl
Alt Del
command or the
RESET
button. See
“Resetting Your Computer” in Chapter 3 for more
information.
8.
If resetting the computer does not work, turn it off and
wait at least five seconds. If you do not have a hard disk
drive, insert the Startup or Reference diskette in drive A.
Then turn on the computer. It should load MS-DOS.
9.
If you installed a display adapter card in your computer,
and you want to use that adapter as your primary display
adapter, you need to change the setting of jumper Jl on
the main system board to disable the built-in VGA
adapter. If you have not set the jumper, you will not see
any display on the screen. You may also need to set
jumpers J3 and J5. See “Changing the Jumper Settings” in
Chapter 6 for instructions.
Password Problems
If you set a password using the SETUP program, you must
enter it before you can use the system. When you turn on the
computer, it runs a memory test. Then the screen displays
the Enter Password
prompt. If you do not enter the correct
password, you cannot use the computer.
If you have any trouble using your password, try the
following:
P
If you type the password and press
Enter
but nothing
happens, type it again and press
Enter.
Cl
If you know the current password but you want to
change or delete it, see Chapter 2 for instructions.
0
If you do not know the current password, follow the steps
below.
Troubleshooting C-5