Filter
Top Products
Page length
This option is only available when you use continuous paper
with the optional push tractor. You can set the page length to
8.5, 11, 12, or 70/6 (A4) inches.
Skip over perforation
When this option is set to on, the printer ships over the
perforations of continuous paper so that it provides a 1-inch
margin between the last line printed on one page and the first
line printed on the next page. Since most application programs
insert their own top and bottom margins, you should use this
feature only if your program does not provide it. This feature is
active only if you install the optional push tractor.
Tear-off position
When you use continuous paper with the optional push
tractor, this feature advances the paper so you can tear off the
printed page and then reverses the paper so you can use all of
the next sheet. You can choose from two tear-off positions with
this printer.
If you select On cutter, the printer feeds the paper perforation
to the paper cutter on the edge of the printer cover. If you
select Above cutter, the printer feeds the perforation about
25 mm (1 inch) beyond the printer cover.
TOF (top-of-form) position
Whenever you press the
FF
button or send the form feed
command, the printer loads paper to the set top-of-form (TOF)
position. The TOF position is factory set to the 0 position,
which is 8.5 mm (0.33
inches) from the top edge of the paper.
You can set this position from 5.5 mm (-3) to 11.5 mm (+3) in
1-mm increments.