Filter
Top Products
Once you select hex dump or demonstration, turn off the
printer and wait five seconds. To enter the hex dump mode or
print your selection, hold down both the
FF
and
FONT
buttons
while you turn on the printer.
Maintenance and Transportation
Cleaning the printer
To keep your printer operating at its best, you should dean it
thoroughly several times a year.
1.
Make Sure the printer is turned off. Then remove any paper
as well as the paper cassette and output guide. Also
remove the optional push tractor, if installed.
2.
Use a soft brush to carefully brush away all dust and dirt.
3.
If the outer case or paper cassette is dirty or dusty, clean it
with a soft, clean cloth dampened with mild detergent.
Keep the printer cover in place to prevent water from
getting inside the printer.
Caution:
Never use alcohols or thinners to clean the printer; these
chemicals can damage the components as well as the case.
Do not use a hard or abrasive brush.
Do not spray the inside of the printer with lubricants;
unsuitable oils can damage the mechanism. Contact your
dealer or a qualified service person if you think lubrication
is needed.
Be careful not to get water on the printer mechanism or
electronic components.
3-14
Using the Printer