Filter
Top Products
Solving Problems 131
You can’t connect to the projector using EasyMP Network
Projection.
■ Make sure the network cable is connected, as described on
page 80.
■ If you are using the optional wireless LAN module, make sure it is
installed correctly in the projector, as shown on page 83.
■ Restart your computer.
■ Make sure your projector and computer are configured correctly;
see page 88 (configuring the projector) or page 90 (configuring
the computer).
■ If you are using the optional wireless LAN module, make sure
that you have sufficient wireless signal strength (above 50
percent). On a Mac, check the AirPort icon on the Mac menu
bar. In Windows, see the documentation for your computer’s
wireless card or adapter for details.
■ Make sure you aren’t projecting one of the EasyMP Network
Projection screens. (You should see a message that the projector is
ready to connect.) If you have to exit a configuration screen,
restart EasyMP Network Projection.
■ If the projector is configured for Access Point mode and you’re
using DHCP, allow time for your projector to appear. It takes the
server a little while to pick up the IP address.
■ If you’ve changed any settings for your projector or network, or
restarted your computer, allow a minute or two for the
connection to appear. If you’re using AirPort, try turning AirPort
off and then on again.
■ Make sure that you’re trying to connect to the right network. In
Windows, verify that you’ve enabled your computer’s connection
to the access point or that your wireless card or adapter is enabled
and connected to the same SSID as the projector. On a Mac, click
the AirPort icon at the top of your Mac desktop to make sure
AirPort is turned on and the right network is selected.