Filter
Top Products
92 Using the Projector on a Network
5. For the WEP encryption setting, select
128Bit or 64Bit and press
Enter. Press Esc to return to the previous menu.
6. For Format, highlight
ASCII to enable text input or HEX to
enable hexadecimal input, then press
Enter. Press Esc to return to
the previous menu.
7. If you chose
64Bit as WEP Encryption, choose Encryption key
1, 2, 3, or 4. Press Esc to return to the previous menu.
Highlight the
Encryption key that corresponds to the Key ID
you selected, then press
Enter. Use the arrow buttons to select
individual letters; then press
Enter to input a character. To
navigate backward and forward through the input text, highlight
the arrows and press
Enter. To toggle symbol settings or capital
letters, highlight the option and press
Enter. When you’re done,
highlight
Finish and press Enter.
8. Check with your network administrator for directions on entering
a key for your network, and follow these general guidelines:
■ For 128 bit WEP encryption with hexadecimal input, enter
26 characters, from 0 to 9 and from A to F.
■ For 64 bit WEP encryption with hexadecimal input, enter 10
characters, from 0 to 9 and from A to F.
■ For 128 bit WEP encryption with ASCII or text input, enter
13 alphanumeric characters.
■ For 64 bit WEP encryption with ASCII or text input, enter 5
alphanumeric characters.
9. For Authentication Type, select
Open or Shared, depending on
the setting your network uses. Press
Esc to return to the previous
menu.
note
Text input for WEP
encryption varies with
different access points; check
with your network
administrator. Try ASCII
first. If that doesn’t work,
try Text2 and then Text3.