Filter
Top Products
Customizing Projector Features 39
■ Input Signal
Adjust these settings for the type of equipment connected to the projector:
Video Signal: Leave this setting on Auto so the projector can automatically interpret
the format, such as NTSC or PAL (for standard TV formats).
Input A (or Input B): Change this setting to match the type of equipment connected to
the Input A (or Input B) port:
■ For component video, select Component (Auto) to let the projector automatically
interpret the signal; or select
Component (YCbCr) or Component (YPbPr) to
manually select your video equipment’s signal.
■ Select RGB-Video if your video equipment outputs a signal in RBG format.
■ Select RGB if you’ve connected a computer.
D4: Change this setting to match the type of equipment connected to the D4 port (used
mainly in Japan).
■ Trigger Out
Turn on this setting if you want the Trigger out port to output a 12-volt signal while
the projector is operating. You can use this to raise or lower your projection screen.
■ Sleep Mode
Turn off this setting if you don’t want the projector to enter sleep mode. (Sleep mode
shuts the projector off automatically when there is no video signal.) Select
30 min.,
10 min., or 5min. as the length of time before shutoff; decreasing the time conserves
power and extends the life of the lamp. To turn the projector back on, press the
On
button on the remote control, or press the
Power button on the projector.
■ Button Illumination
Lets you turn off the illumination of the control panel buttons on the projector.
■ Lock Setting
Lets you lock the projector’s focus and zoom settings, or lock the projector’s control panel
to make it more difficult for a child to turn on the projector. See page 25.
Setting ! Input Signal
Setting ! Operation ! Trigger Out
Setting ! Operation ! Sleep Mode
Setting ! Operation ! Button Illumination
Setting ! Operation ! Lock Setting