Filter
Top Products
60 Solving Picture Problems
The temperature light is flashing orange.
High-speed cooling is in progress. If the projector gets too hot again, projection stops
automatically. Make sure there is plenty of space around and under the projector for
ventilation. Clean or replace the air filter if necessary (see page 54).
The temperature light is red.
The projector is too hot, which turns off the lamp automatically. Let it cool for five minutes,
then turn it back on. Make sure there is plenty of space around and under the projector for
ventilation. Also, clean or replace the filter if necessary (see page 54).
The lamp light is flashing orange.
The lamp needs to be replaced soon (see page 56). Make sure you have a spare lamp handy.
The lamp light is red.
■ The lamp needs to be replaced (see page 56).
■ If you just replaced the lamp, the cover may be loose or off. Make sure it’s securely
fastened (see page 56).
The lamp and/or temperature light is flashing red.
There is an internal problem. Disconnect the projector from its electrical outlet and contact
EPSON for assistance (see page 65).
Solving Picture Problems
You cannot turn on the projector.
■ Make sure the power cord is connected, then wait a moment for the P power light to
turn orange before pressing the
Power button.
■ If you’ve set the Operation Lock, the control panel buttons are disabled; you must use
the remote control to turn on the projector (see page 25).
■ If you’re trying to turn on the projector from Cinema Color Editor, the projector
must be connected via a network cable and
Network Monitoring must be enabled
(see page 44).