Filter
Top Products
EPL-N2700 Revision A
Product Description Panel Operation 37
NOTES:
1: Appears only when an optional PostScript Level 3 DIMM is installed.
2: Appears only when an optional TypeB Interface Card is installed.
3: Appears and can be selected only when an optional lower cassette unit is installed.
4: Does not appear on the panel nor status sheet.
5: When "Auto" is selected, the following paper sizes can be detected.
- North American version: LT, HLT, LGL, EXE, GLG, GLT, B
- Other versions:A3, A4, A5, IB5, LTR, LGL, F4
6: Appears and can be selected only when 5-Bin Unit or 10-Bin Unit is installed and
the Stacker mode is enabled.
7: Appears and can be selected only when 5-Bin Unit (Mail box 1 - 4) or 10-Bin Unit
(Mail box 1-9) is installed in the Mailbox mode.
8: Does not appear.
9: Effective only in the ESC/Page or PCL mode.
10: Appears only when an optional Duplex Unit is installed.
11: Appears only when an optional 5-Bin Unit or Finisher is installed.
12: Does not appear.
13: Appears but not to be selected.
14: STANDBY command of the EJL is also supported. The default is 60 minutes. (Not
intended for users.)
15: Does not appear on the panel nor status sheet. Only set in EJL.
16: Appears only in the GLike mode.
17: The selected value is not effective until the next warm boot or power on.
18: Appears only when the NLSP Bitmap 3 Plus ROM DIMM is installed.
19: Default for the North American version.
20: Default for the versions other than the North American version.
21: Appears even though the optional unit is not installed. The counter is also cleared.
22: Either “Height” or “Pitch2 appears, depending on the selected font type;
- Constant pitch font: “Pitch”
- Proportional pitch font: “Height”
23: Appears only when an optional Font DIMM is installed in the optional ROM DIMM
Socket.
24: Appears when the maintenance menu is activated by the power-on service
function.
25: Appears and can be selected only when an optional 5-Bin Unit or 10-Bin Unit is
installed in the Sorter or MultiSort mode.
26: Does not appear on the panel nor status sheet but can be set in the EJL or PJL.
27: Appears and can be selected only when an optional 5-Bin Unit or 10-Bin Unit is
installed. After exiting the panel setting mode in which the selection has changed,
warm-boot is executed. Also, after the selection has changed, "Test Menu" is not
shown until the panel setting mode is terminated.
Table 1-28. SelecType Option (7/7)
MENU Button
ITEM Button VALUE Button
Maintenance Menu
*24
Engine Status Sheet
Fuser Counter Clear
MP Counter Clear
LC1 Counter Clear
LC2 Counter Clear
*21
LC3 Counter Clear
*21
TR Counter Clear
Errlr Long Clear