Filter
Top Products
The New Hardware Found screen appears even though the
printer software has already been installed.
Cause What to do
This error may occur when
using Windows 95.
Click the
Do not install a driver
(Windows will not prompt you
again)
button; then click
OK
.
Paper handling
Paper does not feed properly from the paper tray.
Cause What to do
Too many sheets are loaded
in the paper tray.
Take the paper stack out of the tray,
remove some sheets, and reload the
stack. Before you load paper, see page
2-5 to check the amount of paper you
can load in the paper tray.
The edge guides are not set
correctly.
Adjust the guides against the stack of
paper. See “Loading Paper in a Paper
Tray” on page 2-7.
Paper is jammed in the paper
path.
Take all of the paper out of the paper
trays and manual feed slots, and
reload paper in the paper tray. If all of
the paper out lights continue to flash,
turn off the printer and pull out any
paper that may be jammed in the
printer. See page 8-29 for more details.
Paper has been compressed
and is sticking together.
Fan your stack of paper before loading
it.
The paper is curled or folded. Use flat, undamaged paper.
The paper is old or creased. Use only new, smooth sheets of paper.
L
Keywest Ref. Guide
Rev.c
A5 size Chapter 8
10-09-97 DR, pass 0
8-16
Troubleshooting