Filter
Top Products
Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
93 92
TM-T88III series
Specification
(STANDARD)
B
ESC J n
[Name] Print and feed paper
[Format] ASCII ESC J
n
Hex 1B 4A n
Decimal 27 74 n
[Range] 0 ≤ n ≤ 255
[Description] Prints the data in the print buffer and feeds the paper [
n × vertical or horizontal motion unit].
[Details]
• After printing is completed, this command sets the print starting position to the beginning of
the line.
• The paper feed amount set by this command does not affect the values set by ESC 2 or ESC
3
.
• The horizontal and vertical motion unit are specified by GS P.
• The GS P command can change the vertical (and horizontal) motion unit. However, the
value cannot be less than the minimum vertical movement amount, and it must be in even
units of the minimum vertical movement amount.
• In standard mode, the printer uses the vertical motion unit (y).
• In page mode, this command functions as follows, depending on the starting position of the
printable area:
① When the starting position is set to the upper left or lower right of the printable area using
ESC T, the vertical motion unit (y) is used.
② When the starting position is set to the upper right or lower left of the print able area using
ESC T, the horizontal motion unit (x) is used.
• The maximum line spacing is 1016mm {40"}. When the setting value exceeds the maximum,
it is converted to the maximum automatically.
[Reference]
GS P