Filter
Top Products
2-8
Setting Up the Scanner
R4C0910
Rev. C
A5 size SETUP.FM
1/12/00 Pass 3
L
Proof Sign-off:
SEI Y.Takasaki M.Fujimori
M.Fujimori
SEI M.Kauppi
Connecting the Scanner to Your Computer using the
SCSI Interface
For instructions on connecting the scanner to your computer
using the SCSI interface, read this section.
Note for Macintosh Users:
Be sure to install the scanner software before connecting the scanner to
your computer. See Chapter 3 for details.
For PC users:
Unless your PC already has a SCSI board installed, you need to
install one, along with SCSI driver software. Install the SCSI board
according to the directions included with it. Also see “Installing
a SCSI Interface Board (SCSI Interface Users Only)” on page 2-4.
If your PC has a SCSI board up and running, connect the scanner
as described in the next section.
Note:
You will need to install the SCSI driver that is normally included with
Windows 95, 98, or NT (see your system documentation for
instructions), or the driver described in the SCSI board installation
documentation.
For Macintosh users:
Your Macintosh may or may not have SCSI ports, depending on
which model you own. If you have a new Power Macintosh G3,
you need to install a SCSI board and driver. See “Installing a SCSI
Interface Board (SCSI Interface Users Only)” on page 2-4. Follow
the directions below to connect your scanner and computer.
Note:
The latest driver may be available for download from the Web site of the
SCSI board manufacturer.