Filter
Top Products
2
Setting Up the Scanner
2-13
R4C0910
Rev. C
A5 size SETUP.FM
1/12/00 Pass 3
R
Proof Sign-off:
SEI Y.Takasaki M.Fujimori
M.Fujimori
SEI M.Kauppi
Connecting the scanner
Connect the scanner to your computer or to another SCSI device
as follows:
Note:
The combination of connectors on the SCSI interface cable you need
varies depending on the maker of your SCSI device and SCSI interface
board.
1. Make sure the scanner, computer, and all other SCSI devices
are turned off and unplugged from the power source.
c
Caution:
Do not connect the scanner to the computer or other devices
while they are turned on as damage may occur.
2. Connect one end of the interface cable to one of the scanner
SCSI connectors until the locks on both sides snap in.
Note:
❏
To connect the scanner to a SCSI device other than the
computer, the length of cable in the daisy chain must not exceed
6 meters; otherwise the system may not work properly.
❏
To connect the scanner to a PC using SCSI-2, the length of the
cable must not exceed 3 meters.
❏
Make sure no other interface is used.