Filter
Top Products
3.1 OVERVIEW
This section describes procedures for disassembling the main components of the printer. Unless otherwise
specified, disassembled units or components can be reassembled by reversing the disassembly procedure.
Therefore, no assembly procedures are included. Precautions for any disassembly or assembly procedure are
described under the heading “Disassembly/Assembly Points.” Adjustments required after assembling the unit
are described under the heading “Required Adjustments.”
3.1.1 Precautions for Disassembling the Printer
See the precautions below when disassembling the printer.
❏Disconnect the power cable before disassembling or assembling the printer.
❏Wear goggles to protect your eyes from ink. If ink gets in your eye, flush it with fresh water
and see a doctor immediately.
❏If ink comes into contact with your skin, wash it off with soap and water. If irritation
occurs, contact a physician.
❏Never remove the ink cartridge from the carriage unless manual instructions specify to
do so.
❏When transporting the printer after installing the ink cartridge, be sure to pack the
printer for transportation without removing the ink cartridge.
❏Use only recommended tools for disassembling, assembling, or adjusting the printer.
❏Use onlyO-11 oil when lubricating the carriage guide shaft.
❏Apply lubricants and adhesives as specified. (See Chapter 6.)
❏Make specified adjustments when you disassemble the printer. (See Chapter 4.)
3.2 DISASSEMBLY AND ASSEMBLY
This section consists of the subheads shown in the diagram below. See the exploded view of the printer in the
Appendix, if necessary.
Follow the precautions in Section 3.1.1 when disassembling the printer.
This section consists of the subheads shown in the diagram(next page).
WARNING
CAUTION
WARNING
EPSON Stylus Color 200 / EPSON Stylus 200 Disassembly and Assembly
Rev. A 3-1